U.S. Membership (Sa - Sw): 89
|
|
Adam Sachs |
|
Gordon Sallee (Email not working 08/2006) Trophy Club, Texas -- I have been working on a steam engine, powered by hydrogen, produced by electricity, generated by a generator driven a steam engine. I look forward learning more about your steam turbine engine kit. For my purposes I need more than a model however. |
|
Bob Salopek Renegade2_bob_AT_hotmail_DOTcom McKeesport, PA -- 08/25/07 |
|
Dean Salvadore |
|
Pat Salvati |
|
Gonzalo Sanchez Cuadrado Guaynabo, Puerto Rico -- 01/12/07 My design self maintentance power Generator |
|
Frank Sander (Email not working 08/2006) Sikeston, MO -- I am a Machinist/Mechanic JRNYMN 25 yrs experience. Presently employed at a coal-fired steam generating plant with 2 600-MGW units. I became interested in the Tesla turbines a few years back but really never started building one till a few months back. I have not even gotten the discs built yet (I work slow) but I stumbled on this site and I have picked up some very interesting ideas. I have some various ideas myself that I will share when I get my disc design built. It is really great and refreshing to see a site where ideas and photos are being shared. The convergent/divergent nozzle is especially interesting and I hope to use this in my machine. later dudes |
|
Robert Sandham rwsandham2000_AT_yahoo_DOT_com |
|
Allan Sandy Laurel, Maryland -- http://www.ibisltd_DOT_com/ I have designed a system to obtain hydrogen from electrolysis of seawater. This hydrogen fuel source to power personal craft of my own design. I am using one Tesla turbine to power two pumps used for lift, thrust, control and braking. Seek collaboration on Issues such a high pressure gas tanks, high/low pressure conversion valves, lightweight/high strength materials, machining, assembly and general manufacturing. |
|
Dale Saner Email unlisted Norristown, Pennsylvania -- 02/22/07 Strong interest in alternative energy, and ultra efficient devices |
|
Robert Sauer (Email not working 08/2006) Brielle, New Jersey - I am currently working on a hover craft that uses a three prop system that is configured like a tripod. need to be as light as possible. I am looking for advice on building a turbine that produces 20hp @ 14000rpm |
|
Jerry Saunders sunstreamenergy_AT_charter_DOT_net Jacksonville, Oregon -- www.sunstreamenergy.com I design and build renewable energy systems. Off-grid energy is my specialty. |
|
John Savage sugarbooger2_AT_worldnet.att_DOT_net Wilmington |
Joe B. Savoie |
|
Erich Schaal |
|
Dustin Scheve |
Leon Schmidt |
|
Keith Schoeck |
|
Ralph Schubert (Email not working 08/2006) Plantation, Florida |
Robin Schulemann |
Tim Schultz |
Bob Schumacher |
Steve Schwartzkopf |
Dwight Schwebke |
|
Scott Scoble (Email not working 08/2006) Las Vegas, Nevada |
|
Jeffrey Scott |
|
Tom Sears sears-west_AT_sbcglobal_DOT_net Carlsbad, California -- working on a solar electric system using a combined power/cooling cycle. |
|
Lowell
Sheffield Rockville, Maryland -- 06/21/07 Interest: Generation of electricity using hydrogen/steam/Tesla Turbine |
|
Stefan Segal (Email not working 08/2006) Philadelphia, Pennsylvania - An unflagging interest in energy production coupled with almost equal desire to free us from the energy cartels and their pollution of this planet |
Fred Seton |
|
Wayne Shekailo Manassas, Virginia |
DAVE SHELBY |
Mark Sherman |
| Michael Shonka mshonka_AT_qwest_DOT_net Omaha, NE -- 01/25/08 www.solaromaha.com I was looking for "solar steam generation" on Google and found the club... cool! I have been in the solar business since 1983 and have often thought of some of the things that you have described on the web site... My web site is focused on answering the questions that I get most often about solar for homes. I have recently been contacted by a college that is interested in solar for demonstration and their central steam plant (!!!)... hence my renewed research interest. |
|
Richard Shooks |
|
Larry Short paladin_at_heart_AT_yahoo_DOT_com Independence, Missouri |
|
Michael Shuetz |
|
Tim Sikora Kettering, Ohio -- I'm an aero engineer working for the Air Force. I discovered the Tesla turbine concept online and became fascinated with it. I've built a 4.375 inch 6 disk unit that I'm experimenting with using shop air. I'm now building a dynamometer to evaluate changes in horsepower as I vary parameters. So far I've gotten it to 10000 rpm, without pushing it. I've backed off until I can convince myself that I'm not going to fail the disks structurally. |
Bill Siegel |
|
Thomas W. Sima thomaswsima_AT_hotmail_DOT_com Streamwood, Illinois -- http://www.manisteeiron.appgas_DOT_com/ (The Movie) or http://www.ktlebeau.empexis_DOT_com/ If Tesla got 60% efficiency 90 years ago what would it take to get 90% efficiency and 2,800 bhp (SAE) and 3,000 lbs. ft. of torque in a package that would fit in an Indy 500 car and run on heavy waste oil or hydrogen/H20 steam??? Death to the piston dinosaurs! |
|
Walt Simmons sail(nospam)_AT_centramedia_DOT_net Wheeler, Texas - Home machine shop. Moving off grid. Interested in homebuilt solar and wind power. |
|
Timm Simpkins St. George, Utah – 04/30/04 Devoted tinkerer and thinkerer |
|
Dave Sipe Fletcher, Ohio |
|
Chaks Siva Fairfax, Virginia |
|
Allen Slaughter |
|
Jeff Slayton (Email not working 08/2006) Battle Creek, Michigan |
|
James V. Sleuter (Email not working 08/2006) Mckinlyville, California -- male, 48 yrs, machinist, interested in self-sufficiency, low cost water power plants & water pumps |
Angela Smith |
Brendan Smith |
Charles Smith |
|
Ed Smith Albuquerque, New Mexico |
|
Edward Smith naturalistclimber_AT_yahoo_DOT_com Carlisle, Pennsylvania -- I am interested in constructing an electric power generation system using a steam turbine driven by a solar water heater. |
Jeffrey Smith |
|
Jonathan Smith Farmington, New Mexico -- 08/19/07 Interested in a cogeneration system for domestic use using used motor oil, then maybe move on to solar. |
John Smith |
|
Ken Smith Topeka, Kansas -- I have been interested in alternative energy sources for quite some time, and I'm especially fascinated by the bladeless turbine and it's possible uses. |
|
Mark Smith Waterford, Michigan |
|
Paul Smith (Email not working 08/2006) Lake Oswego, Oregon -- I am a retired prototype technician that loves to work on new things. I am getting my shop set up and will be able to experiment with some Tesla projects. |
| Roxie Smith bobo81341_AT_yahoo_DOT_com Davenport, Iowa -- 10/16/07 I serve a machinist apprentice ship at Murray Iron Works building steam turbines. After graduation I hired in at Alcoa as maintenance machinist where I put in over 31 years before retiring. I would like to build a steam turbine similar to a Murray. It has been to long sense working there to remember the details. I would like it to be a scale model no larger than about 10" in length. I would appreciate any help or ideas on this project. |
|
Dot Sony |
|
Chris Southerland |
|
William J. Sovitski |
|
Louis Spencer |
|
Christopher Spohn Poteau, Oklahoma -- 11/21/06 I am interested in the building some form of Solar Power. |
|
Joshua Spotts jspotts_AT_webaspire_DOT_com |
Andy Springer |
S Stanfield |
Martin Stanke |
Jim Stansbury |
Marv Stark |
JC Steel |
|
Kirk Steele Woburn, Massachusetts -- Retired US Navy, Nuclear Electronics Technician. Bored, looking for a "productive" distraction. I think I found one..... |
|
Phil Steenstra |
Trevor Steven |
| Ralph Stevens ralphmyla_AT_netzero_DOT_net Lutz, Florida -- 11/29/07 |
| Tom Stevens tallspruce_AT_usa_DOT_com Killingworth, CT -- 01/28/08 Pls enrol me in "the club"... I have been interested in passive solar since 1955 (I was 15) when two 1000sf single story homes were built with a 60sf window facing south and a 12" slab on grade in Ontario, across Lake Huron from Bay City, MI. No insulation either around the edge of the slab or under it; the temp rose to 85deg at the end of summer, and only down to 70deg at the end of Mar! - Remember that solar flares can interrupt electrical flow at least, and wreck controllers at worst. Do you design your turbines to withstand a solar blast? Carry on the good fight! |
|
JOHN STEWART RALIEGH, NORTH CAROLINA |
|
Tom Stivers |
|
Ted Stoltenberg Georgetown, Texas -- 08/17/07 Systems & Process Control Engineer |
| Brion Storm storm5_AT_rr1.net Greenup, IL -- 01/31/08 Like many others I have a desire to build something practical to use the sun's energy. |
Edward Strunk |
|
Brent W Studer Genesee, Idaho -- 01/27/07 |
| Chris Suaso zuazo_AT_truvista.net Edgemoor,S.C. -- 01/30/08 I've been looking for a clean energy source that i can produce on my own. solar panels are still to costly. I came across this website two days ago and i think this is where I will find what I'm looking for. thanks |
| Frank Sudia San Francisco, CA -- www.fwsudia.com Evaluating a possible Tesla turbine project. |
Brian Sullivan |
terry surma |
Tyler Sweat |
|
David Swider dswider_AT_gmail_DOT_com |
|
Alan Swithenbank |
U.S. Members, A - D 
U.S. Members, E - I
U.S. Members, J - M
U.S. Members, N - R
U.S. Members, Sa - Sw
U.S. Members, T - Z
Last updated: May 05, 2008 11:40 PM
FREE Open Source Forum
Use Edit/Find on your browser to search for keywords on this page.